Hardwood Floor Water Damage Restoration in Naples is what we do every week, from Old Naples bungalows to Pelican Bay high-rises. If a burst pipe, slab leak or storm flooding soaked your oak or maple, our IICRC-trained crews extract standing water, dry the subfloor and save boards most companies would rip out. We answer calls 24/7 and reach most Naples addresses within 60 minutes.
Tell us what is happening. Our local team will confirm your visit shortly.
Call Now +18773640731 → No spam. No obligation. Just practical help.
Hardwood Floor Water Damage Restoration in Naples is the process of removing standing water, drying the wood and subfloor to a safe moisture content, then repairing or refinishing boards that have swelled, cupped or lifted. Solid oak and engineered planks absorb water through seams and end joints, so the clock matters. We map moisture with a moisture meter and thermal imaging camera, extract with a water extraction unit, then run air movers and dehumidifiers until readings match a dry reference room.
Naples homes take on water in predictable ways: a burst pipe behind a kitchen wall, an appliance leak under a refrigerator, a slab leak that wicks up through the flooring, or storm flooding after a tropical system pushes water under a door. Humidity here sits above 70 percent most of the summer, so wood that stays wet for 48 hours starts to cup and grow mold. If you are searching for hardwood floor water damage restoration near me in Naples, call us before the boards crown.
Every hardwood floor water damage job starts with an inspection and ends with a drying report. Here is what is covered in a standard restoration, and what we handle as an add-on when the damage goes further than the floor itself.
We check every room with a moisture meter and thermal imaging camera, log readings against a dry reference, and identify how far the water traveled under baseboards and into adjacent rooms. You get a clear picture of the affected area before any equipment is set.
Standing water comes up first with a water extraction unit, and a submersible pump handles any water in a lower level or crawlspace. We work the seams and end joints where water hides, because surface extraction alone leaves moisture trapped in the wood.
We position air movers and dehumidifiers to dry the floor and the subfloor together, checking readings daily. Most jobs run three to five days. We adjust equipment placement as the floor dries so the edges and center reach the dry standard at the same time.
Wet wood is a mold risk within 48 hours. We apply antimicrobial spray to affected areas, run an air scrubber to capture airborne spores, and inspect the cavity behind baseboards. If growth is present, we bring in licensed mold remediation before finishing the floor.
Boards that are split or delaminated get replaced with matching stock. Cupped boards that have flattened are sanded level. We screen and refinish the floor to match the existing stain and sheen, then let the finish cure for 24 hours before furniture goes back.
We photograph the cause of loss, log daily moisture readings and write the scope in Xactimate. You get a completion report with photos and the drying log, which is what your adjuster needs to process the claim without delays or follow-up visits.
You call and describe what happened. We ask about the water source, how long the floor has been wet, and whether the power is safe. A crew is dispatched immediately, and for most Naples addresses we are on site within 60 minutes. We shut off the water supply if it is still running and stop the source before anything else.
We walk the floor with a moisture meter and thermal imaging camera to find every wet zone, including water that traveled under baseboards into the next room. Readings are logged room by room against a dry reference point. This takes 30 to 45 minutes and tells us whether the wood can be saved or needs replacement.
A water extraction unit pulls standing water from the surface and seams, and a submersible pump handles any water still in a crawlspace or lower level. We then set air movers and dehumidifiers, often running them for three to five days. You will hear the equipment, and we check readings daily until the wood reaches its dry standard.
Once moisture content is stable, we replace any boards that are split, delaminated or too far gone, then screen and refinish the floor to match. Cupped boards that have flattened are sanded level. Most repairs take one to two days, and the finish cures for 24 hours before furniture goes back.
We take a final set of moisture readings, confirm the floor is dry, and hand you a completion report with photos and the drying log. That document is what your insurance adjuster needs. We also walk you through what to watch for over the next two weeks, like new gaps or a slight change in sheen.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Reads moisture content in wood and subfloor so we know exactly how wet the floor is and when it has reached the dry standard. We take readings daily and log them for your insurance claim.
Shows us where water traveled behind walls, under baseboards and into adjacent rooms without tearing anything open. It is how we find hidden moisture that a visual inspection would miss.
Pulls standing water off the floor surface and out of seams and end joints. Fast extraction in the first hour is the biggest factor in whether your boards can be saved.
Removes moisture from the air so the wood releases water faster. We run desiccant units on hardwood jobs because they perform better in Naples humidity than refrigerant dehumidifiers.
Moves air across the floor surface to speed evaporation. We position them to dry the edges and center of the room at the same rate so the floor does not dry unevenly and cup.
Filters airborne mold spores and dust during drying and refinishing. It keeps the rest of your home clean while we work and reduces the chance of mold spreading from the affected area.
Neutralizes musty odors left behind by wet wood and mold. We run it after drying is complete, then air the space out before you move back in.
A supply line failed under a kitchen sink overnight and water ran across 400 square feet of original oak. The floor was cupped along every seam, and moisture readings hit 24 percent in the worst area. The homeowner was ready to replace the whole floor.
We extracted, set air movers and a desiccant dehumidifier, and dried the floor over four days. Readings dropped to 8 percent. We sanded the cupped edges level and refinished the room. The floor is flat and the finish matches the adjacent hallway.
A slab leak soaked 250 square feet of glued-down engineered hardwood in a second-floor unit. Several planks had delaminated and the floor felt spongy near the kitchen. The unit below had a small ceiling stain.
We stopped the leak, dried the slab and flooring over five days, and replaced 18 delaminated planks. The repair was blended into the existing floor and the ceiling below was repaired. Final moisture readings came in at 9 percent.
Wind-driven rain pushed water under a front door and across 300 square feet of living room hardwood. Water sat for about six hours before the homeowner got home. The floor was stained and starting to smell musty.
We extracted, cleaned and sanitized the floor, then dried it over five days. Two boards were replaced and the stained area was sanded and refinished. The musty odor was gone after an ozone treatment. The floor looks original again.
Water damage shows up in different ways depending on the source and how long the floor stayed wet. These are the problems we see most often and how we fix them.
Ask a pro →We dry the floor until moisture content is even top to bottom, then sand the cupped edges level and refinish. Most cupped floors flatten on their own during drying, so we wait for stable readings before touching a sander. This is the core of our hardwood floor water damage restoration for cupping in Naples.
We extract standing water, dry the subfloor, and assess whether the boards can be saved. Crowned boards are sanded flat after drying. Buckled sections are removed, the subfloor is dried and prepped, and new boards are installed and finished to match.
We find the moisture source with a thermal imaging camera, dry the assembly completely, and treat the area with antimicrobial spray. An ozone generator neutralizes the odor at the source. If mold is present, we remediate it before refinishing the floor.
We sand past the stain where the wood allows, then stain and refinish to blend with the rest of the floor. Deep stains that reach the grain may need board replacement. Either way, the finished floor matches the surrounding area.
Most residential jobs in Naples run $1,200 to $4,500 in 2026, depending on square footage, how long the floor was wet and whether refinishing is needed. Extraction and drying alone typically costs $600 to $1,800 for one or two rooms. Board replacement and refinishing add to that. If the loss is covered, your insurance usually pays most of it, and we document everything for the claim.
Yes, most can, if drying starts within 24 to 48 hours. Solid and engineered hardwood that is cupped but not split will usually flatten again once moisture content drops below 10 percent. Boards that are delaminated, crowned beyond repair or contaminated by sewage backup get replaced. We make that call after moisture mapping, not before.
Drying takes three to five days for most Naples homes, with equipment running the whole time. Repairs and refinishing add one to two days, and the finish needs 24 hours to cure. A straightforward two-room job is usually wrapped in about a week. Larger losses with slab leaks or storm flooding can run 10 to 14 days.
Most homeowners policies cover sudden water damage from a burst pipe, appliance leak or storm flooding, but not long-term seepage or neglect. We photograph the cause of loss, log moisture readings daily and write the scope in Xactimate so your adjuster has what they need. You pay your deductible, and we bill the rest directly to the carrier.
Emergency Water ExtractionStanding water on hardwood has to come up before anything else happens. Our extraction crews pull water from the floor surface and seams within the first hour, which is the single biggest factor in whether your boards can be saved or need replacement.Explore →
Water Removal and PumpingWhen a slab leak or storm flooding leaves inches of water across a Naples home, a submersible pump moves it out fast. We pump down the level, then switch to extraction and drying so the hardwood is not sitting in water while we work.Explore →
Flood Water CleanupFlood water carries silt and contaminants that soak into wood grain. We clean, sanitize and dry the floor, then test whether the boards are salvageable. If the flood water was category 3, affected hardwood usually gets removed and replaced rather than dried.Explore →
Burst Pipe Water Damage RepairA burst pipe behind a wall can soak a hardwood floor before you notice. We stop the source, extract the water, open the wall cavity if needed, and dry the floor and subfloor together so the repair holds and the wood does not cup.Explore →
Sewage Backup CleanupSewage backup is category 3 water, which means affected hardwood is almost always removed rather than dried. We handle the extraction, disinfection and disposal, then prep the subfloor so new flooring can go down clean.Explore →
Basement Flood CleanupNaples homes with lower levels or raised foundations can take on water fast during a storm. We pump, extract and dry the space, paying close attention to hardwood on grade where moisture wicks up from the slab.Explore →
Structural Drying and DehumidificationHardwood dries at the same pace as the subfloor and framing beneath it. We run desiccant dehumidifiers and air movers across the whole assembly so the wood is not re-wetting from below while we try to dry it from above.Explore →
Carpet Water Damage RestorationMany Naples homes have hardwood in living areas and carpet in bedrooms. When both get wet, we dry them together so the moisture does not migrate from the carpet pad into the adjacent wood floor and cause cupping at the transition.Explore →Every hour a wet hardwood floor sits, the odds of saving it drop. Our IICRC-certified crews are on call 24/7 and reach most Naples addresses within 60 minutes. Call now and we will extract, dry and document the loss so your floor and your claim both come out right.
Get Emergency Help +18773640731 →Call us any time, day or night, at +18773640731. We answer live and dispatch a crew, usually within 60 minutes across Collier County. If you prefer email, send photos and your address to info@naplesrestoreexperts.com and we will follow up fast.